Difference between revisions of "Kodi (formally XBMC)/wiimote"
Jump to navigation
Jump to search
m |
m |
||
Line 5: | Line 5: | ||
* Next answer yes to any questions regarding space usage by the packages being installed. | * Next answer yes to any questions regarding space usage by the packages being installed. | ||
* Now open the battery cover on the wiimote and locate the internal red button. (leave batteries installed) | * Now open the battery cover on the wiimote and locate the internal red button. (leave batteries installed) | ||
− | * Go back to command line and issue <code>hcitool scan</code> and immediately press the internal red button on the wiimote. | + | * Go back to command line and issue |
+ | |||
+ | <code>hcitool scan</code> | ||
+ | |||
+ | and immediately press the internal red button on the wiimote. | ||
*In the Command line you should get an output that goes something like this | *In the Command line you should get an output that goes something like this | ||
<code>00:1F:32:FC:D8:C9 Nintendo RVL-CNT-01</code> | <code>00:1F:32:FC:D8:C9 Nintendo RVL-CNT-01</code> |
Revision as of 09:35, 24 November 2015
Installing & Configuring Wiimote for Kodibuntu
- Open command line and issue
sudo apt-get install bluez kodi-eventclients-wiiremote
- Next answer yes to any questions regarding space usage by the packages being installed.
- Now open the battery cover on the wiimote and locate the internal red button. (leave batteries installed)
- Go back to command line and issue
hcitool scan
and immediately press the internal red button on the wiimote.
- In the Command line you should get an output that goes something like this
00:1F:32:FC:D8:C9 Nintendo RVL-CNT-01
- You should either take a screenshot of the Bluetooth mac address or write it down somewhere.
- Finally you need to edit the config file located at
sudo nano /etc/rc.local
and insert the following at the bottom
kodi-wiiremote --btaddr 00:1F:32:FC:D8:C9 &
- Make sure this is inserted before "exit 0"
- Obviously you will need to replace the mac address with the one that you wrote down earlier.
- Don't leave out the "&" at the end of the insertion.
- Save the file and restart.
- Once restarted all you need to do is hold down the 1 and 2 buttons and it should connect soon after.